« previous next »
Pages: [1]

Author Topic: Spreader Mount  (Read 4979 times)

Brian Denney

  • Wannabees
  • U20 Youngster
  • *
  • Posts: 26
Spreader Mount
« on: April 03, 2017, 01:15:52 PM »
We have managed to bend the aluminum mount that runs thru the mast that the spreaders attach to. Will it cause any concern simply bending back into place? Obviously this is a pretty important part and breaking it under sail would be a very bad thing. Second question is does anyone know where to source a new one, or will I need to fabricate one myself?
Thanks - Brian
Logged
Honey Badger #124

Travis Gregory

  • Administrator
  • U20 Enthusiast
  • *****
  • Posts: 245
  • U20 - 222
Re: Spreader Mount
« Reply #1 on: April 06, 2017, 03:38:17 AM »
My advice would be to check with Ballenger.  http://www.ballengerspars.com

Good luck! 
Logged

Brian Denney

  • Wannabees
  • U20 Youngster
  • *
  • Posts: 26
Re: Spreader Mount
« Reply #2 on: April 06, 2017, 12:13:17 PM »
Thanks Travis I will take a look. Also I looked at the U20 setup guide and I guess this spreader bar is stainless steel and not aluminum. Perhaps carefully bending back into place would not stress it as much as if it were aluminum.
Logged
Honey Badger #124

Don Corey

  • Active Member
  • U20 Enthusiast
  • **
  • Posts: 145
Re: Spreader Mount
« Reply #3 on: June 04, 2017, 08:53:34 PM »
Sure, the spreader is stainless and can be bent back into shape with no problem, not out flat though.  Each side tips up a few degrees.  Sorry I did not see this post earlier............. Don
Logged
Don Corey   #25  fore 
U20 Class member since 1997
Pages: [1]
« previous next »