« previous next »
Pages: [1]

Author Topic: Spinnaker pole sleeve bolt has broken out  (Read 4208 times)

John Wolfe

  • #180
  • Active Member
  • U20 Youngster
  • **
  • Posts: 42
Spinnaker pole sleeve bolt has broken out
« on: September 20, 2022, 06:10:14 PM »
One of the bolts holding the foremost front of the spinnaker pole sleeve has managed to break the upper portion of the lip that holds the bolt.  See attached photo.  The photo is from outside the boat looking up under the pole.

I was thinking I would fill this broken off top piece with epoxy and fiber filler and then re-drill and tap the hole for the bolt. 

Another thought I had is that I should move the foremost bolt aft an inch or so in order to use new material and skip filling the broken off top piece.

Thoughts appreciated.

Thanks!
 
Logged

Mike Reyes

  • U20 Youngster
  • **
  • Posts: 42
Re: Spinnaker pole sleeve bolt has broken out
« Reply #1 on: September 20, 2022, 06:54:25 PM »
I would give Craig Smith at Elkhorn Composites a call. He has the molds to make the pole sleeve ( called the snail) or could repair. He is also great for advice. He worked for Moore building the first 30 U20s. If you call Craig, leave a voice-mail if he doesn't answer and he is good about returning your call.
« Last Edit: September 20, 2022, 07:02:09 PM by Mike Reyes »
Logged
Mike Reyes
#16 Nostalgia

U20 Site Moderator

  • Administrator
  • U20 Old Timer
  • *****
  • Posts: 85
Re: Spinnaker pole sleeve bolt has broken out
« Reply #2 on: September 20, 2022, 07:05:06 PM »
Logged
Pages: [1]
« previous next »