At the 2026 NA's, I was asked if I could make some spinnaker pole end plugs. I ordered material at the beginning of October and I just received it. I chose exterior grade shatter resistant nylon. It's only available in black. I've got enough material to make 8 -10 sets. My boat is not home right now, it's at Richmond Yacht Club so I can't measure the ID and OD of the poles ends. If someone can give me the exact ID and OD of each end of the spinnaker pole, preferably with an accurate calipers, I can machine some up and bring them to RYC for the mid-winters. I can also UPS them out. I estimate they will cost $60/pair.