« previous next »
Pages: [1]

Author Topic: Caron Mast Spreader bushing?  (Read 4170 times)

Clifford Begnaud

  • #126 Underdog
  • Active Member
  • U20 Virgin
  • **
  • Posts: 24
Caron Mast Spreader bushing?
« on: May 17, 2011, 01:54:15 PM »
I'm rigging up my carbon mast and the last step is to drill the end of the spreaders for the shrouds. It seems like the shrouds would cut into the carbon spreader, should a bushing of some sort be used to prevent this. What are you carbon equipped guys doing?
thanks,
Cliff
Underdog #126
Logged

André Labelle

  • #184 Low Rider
  • Inactive
  • U20 Virgin
  • *
  • Posts: 22
Re: Caron Mast Spreader bushing?
« Reply #1 on: May 17, 2011, 02:04:53 PM »
I have used a small piece of shroud plastic cover (snap-on cable covers - West Marine $1.99).  About 2 inches and taped a small section each side of the spreader so it does not move within the spreader.  Looks good and does the job.
« Last Edit: May 17, 2011, 02:17:43 PM by André Labelle »
Logged
Pages: [1]
« previous next »